Roofing

An ideal support assembly for freestanding fireplaces and open cathedral ceiling installations. Fits all roof pitches and requires only simple framing. Mounts easily on to top of roof through opening that allows 2 inch clearance. Maximum length of chimney which can be suspended below is 20 feet supported. Maximum total length is 30 feet. The Roof Support (RSP) contains one 18 inch length of pipe, roof brackets and necessary hardware. The roof brackets and hardware may be purchased without the pipe section by ordering a Roof Support Kit (RSK). The brackets may be assembled to any standard pipe length at any desired height. Locking bands must be used at each pipe joint when installing either the RSP or RSK.

Flashings are used to seal the opening where the chimney penetrates the roof to divert rain and snow down from the roof and away from the chimney system. A series of adjustable flashings are available depending on your roof pitch. A flat and low pitch flashing is used to seal flat and low pitch roof (up to 2/12 pitch) openings. o determine your roof pitch, measure the number of inches from the end of a level ruler down to the roof.

This adjustable flashing is used on a 12/12 to 24/12 pitched roof, to seal the opening where the chimney penetrates the roof to divert rain and snow down from the roof and away from the chimney system.

Flashing are used to seal the opening where the chimney penetrates the roof and to divert rain and snow down from the roof and away from the chimney system. A series of adjustable flashing is available depending on your roof pitch.

Flashings are used to seal the opening where the chimney penetrates the roof and to divert rain and snow down from the roof and away from the chimney system. A series of adjustable flashings is available depending on your roof pitch. A flat and low pitch flashing is used to seal flat and low pitch roof (up to 12/12 pitch) openings. To determine your roof pitch, measure the number of inch from the end of a level ruler down to the roof.