Pocket & Bifold Door Hardware

This is a guide rod used in Benchmark bi-fold door systems. The 5/16 in. diameter, 5-1/4 in. long steel rod and is threaded on the bottom half with a hex nut and washer. There is a 3/8 in. nylon cap on the end.

These bi-fold door knobs are constructed of diecast and come in a brass plated finish. They feature knobs with a large 1-3/4 in. diameter pull for easy gripping, and a 3/4 in. outside diameter base. These knobs have a 9/16 in. projection, and they can be installed on hollow core and solid doors. This pack of 5 bi-fold door knobs comes complete with 5 fasteners, they are simple to install and used by a variety of wardrobe door manufacturers.

This is a stamped steel 1-3/4 in. round door pull with a polished brass finish. It is pressed into the 2 in. diameter hole in the closet door and held in by a set of nails. Silicone glue may be required if the hole has worn larger. It is used on a variety of closet door manufacturer's doors. There are 2 pulls and 4 nails per package.

This is a polished brass pocket door flush edge pull. It mounts onto the leading edge of a pocket door and has a pull that is pulled out from its flush position to pull the pocket door out of the wall. Afterwards, the pull retracts back into a flush position.

This is a solid brass pocket door pull with a polished brass finish. It fits doors that are 1-3/8 in. to 1-3/4 in. thick. There is a hidden finger pull on the front edge of the pocket door pull. Fasteners included.