Pocket & Bifold Door Hardware

Painted steel track; steel top pivot brackets are pre-installed to track; steel bottom pivot brackets; brass plated steel hinges; roller guides and pivots have a 7/16" diameter plastic base with steel pins; steel spring snugger with plastic retainer sleeve; zinc plated steel aligners; unfinished wood knobs. Track length is pre-cut to slightly less than opening size to minimize the need to cut the track; use with wood door panels 1" to 1-3/8" thick. For use on doors weighing up to 30lbs each.

This is a clear vinyl flat style shower door sweep that is 36 inch long and 1-7/16 inch wide and can be cut to size. It is held onto the swinging shower door by a metal drip rail that is located on the bottom of the door. Easy to install, just remove the screws from the drip rail holding the old sweep and remove. Cut the new sweep to size, determine how far down the sweep needs to hang and install by replacing the drip rail over it and re-installing the screws.

This is a side mounted, top hung wardrobe roller assembly with a single 7/8 in. convex nylon wheel for the front sliding door. The stamped steel bracket assembly is adjustable and has an 1/4 in. offset. It is fitted onto the wardrobe front door and fits 3/4 in. to 1-3/8 in. thick doors. Used by Cox door systems as well as a variety of other wardrobe door manufacturers. For the back wardrobe door see N 6505.

This is a side mount, top hung adjustable roller bracket with a 3/4 in. ball bearing convex nylon roller and 3/8 in. offset that fits onto the front wardrobe door panel. It fits 3/4 in. to 1-3/8 in. thick doors.