Jackel

The Sump Basin Cover is ideal for use with a submersible sump pump where a gas tight seal is not a concern. The corrosion proof single piece cover is injection molded polyethylene structural foam and provides superior toughness and reliability. The solid design allows for discharge and vent holes to be drilled in the field allowing for maximum flexibility. All fitting must be purchased seperately.

The SF24S is a simplex cover that provides a gas and radon tight seal to any of our 24 in. diameter basins. It is constructed of injection molded polyethylene structural foam and is extremely flexible for any simplex pump installation.

The sump basin cover is ideal for use with a submersible or pedestal sump pump where a gas tight sump basin seal is not a concern. The corrosion proof single piece cover is injection molded structural foam polyethylene and provides superior structural toughness and reliability.

The SIH4 Snap In Hub creates a water and vapor tight seal with no caulking. This hub fits on basin sizes from 18 inches to 60 inches in diameter and comes with a stainless steel clamp.

The Original Radon/Sump Dome is designed to cover an existing basin, providing a new heavy duty cover to seal the basin against Radon Gas on odors; to provide adequate safety. There is no reason to dig up your basement or garage floor to remove the existing sump or sewage basin. Simply remove the old cover and install The Original Radon/Sump Dome over the opening, to create a new, completely sealed system.